View Full Version : Problem with installation D-Tools v3.47.0!

19.12.2004, 11:35
Operating System: Windows XP pro. (Service Pack 2)
Burning Software: Nero Burning Rom v6.6.0.0 (Onley)
Anti-virus Software: McAfee 2005 v9.0
DAEMON Tools Version: v3.47.0

I have a problem with installation of DEAMON Tools v3.47.0!
I can't install it! Because all time he own makes reboot of my computer!
Why?! This beginning after I have decided to update the version! Earlier at me was v3.41.0. :?
Sorry for my bad english. :oops:

22.01.2005, 20:23
A problem has been detected and Windows has been shut down to prevent damage to your computer.

The problem seems to be caused by the following file: SCSIPORT.SYS

If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow thase steps:

Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any Windows updates you might need.

If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Sturtup options and then Select Safe Mode.

Technical information:

*** STOP: 0x00000050 (0xF98C1000, 0x00000000, 0xF98C0FFF, 0x00000000)

*** SCSIPORT.SYS - Address F98C0FFF base at F98AC000, DataStamp 41107b4b

Beginning dump of physical memory
Physical memory dump complite.
Contact your system administrator or technical support group for further assistance.

22.01.2005, 20:28
Did you check the thread about BSOD in SCSIPORT.SYS in common problems and solutions forum?

04.02.2005, 18:43
Yes! :twisted:

04.02.2005, 19:23
So what? Did it help? :P