View Full Version : Can't fix d347bus.sys problem

31.05.2005, 03:02
Operating System: Windows XP SP2
Burning Software: Roxio EasyMedia 7.1
Anti-virus Software: Norton Antivirus 2004
DAEMON Tools Version: 3.47

I've run into the dreaded d347bus.sys BSOD problem. After I installed DT and rebooted, I get a BSOD when the d347bus driver is loading (It also happened when I installed alcohol, with its a347bus driver)

The BSOD doesn't generate a minidump (too early in the boot process???) so I can't see what else might be conflicting

As far as I can tell, I don't have any Starforce products.

I tried changing the names of the drivers on install, but that didn't help.

Any other things I can try to make DT work?


31.05.2005, 07:18
Difficult to say, but e.g. Roxio crap is one thing you could check.

Uncle Pain
15.06.2005, 17:43
Operating System: Windows 2000 Pro SP4
Burning Software: Nero 6608a
Anti-virus Software: none
DAEMON Tools Version: 347

I have exactly the same problem: BSOD (PAGE_FAULT_IN_NONPAGED_AREA) on boot, no minidump produced. Any ideas?

20.06.2005, 21:01
Operating System: xp sp2
Burning Software: roxio
Anti-virus Software: norton
DAEMON Tools Version: 3.47

Similar problem with me too!!

Lone Wolf
21.06.2005, 03:51
Operating System: Windows XP
Burning Software: Nero
Anti-virus Software: Norton
DAEMON Tools Version: 3.74

I ran into some problems when installing the program for the first time but I looked

Around in the forums and looked here http://www.daemon-tools.cc/dtcc/portal/daemonhelp.php and read everything then I went here and noticed

This thread http://www.daemon-tools.cc/dtcc/portal/viewtopic.php?t=2287 it wasnt my problem but it still helped out I removed everything from the

System for it and the registry and then alcohol 120% installed it and it worked then

Installed alcohol and now they both work perfectly fine.