PDA

View Full Version : driver error with install



stanleymes
17.09.2005, 10:36
Operating System: wondows xp
Burning Software: nero
Anti-virus Software: trendmicro
DAEMON Tools Version: 3.47

when i install d-tools 3.47 i get the following message,

" some driver has invalid name or conflicts with other file or service in system. please choose other driver names or make sure you have rebooted after removal of software using same names."

thats it, the install rolls back, i don't know with what prog the conflict is.

i had d-tools installed previously and it worked fine.

Copytrooper
17.09.2005, 10:45
http://www.daemon-tools.cc/dtcc/portal/viewtopic.php?t=2287

stanleymes
17.09.2005, 12:10
thnx a lot

its fixed, nothing in the device manager, just the drivers were left behind in the system32 file.

d3rd3vil
18.09.2005, 12:47
Operating System: Windows XP Service Pack 2
Burning Software: Nero,Alcohol120%
Anti-virus Software: Kasperksy Anti Virus
DAEMON Tools Version: Daemon Tools 347

For me it doesnt work :(

1. Open device manager (SCSI/RAID Controllers section) and delete SCSI controller with name corresponding with name of Daemon driver (miniport driver name). If you have problems doing it (eg. system crashes) then start from step 3 (skip steps 1 and 2).

I dont have a SCSI/Raid Controller Section!
I deleted the files in the driver folder and as much as possible in the registry but nothing happens :(

,jACkdA\W
18.09.2005, 22:49
You cannot have the Daemon properly installed without it's corresponding SCSI controller which will show up in the device manager :shock: