Tweet
Sorry if this has been asked before. I used the search function but none of the topics looked related.
I recently installed the latest DT lite version and noticed the method for adding new virtual drives has changed. It now says Add SCSI Virtual drive. When selected it loads for 30 seconds and adds one drive.
I preferred the previous method where the total number of drives (0-4) could be selected at once. On a new install I'd select 4. Letter them Z, Y, X, and W. Then reduce to 1 and the others would already be configured when I want to add them again. 20 seconds total.
With the new method I now add one, wait, set it, add one, wait, set it, add one, wait, set it, remove one, wait, remove one, wait, remove one, wait. Maybe 4 minutes.
Is there some obvious feature I'm overlooking to make this simpler?
I recently installed the latest DT lite version and noticed the method for adding new virtual drives has changed. It now says Add SCSI Virtual drive. When selected it loads for 30 seconds and adds one drive.
I preferred the previous method where the total number of drives (0-4) could be selected at once. On a new install I'd select 4. Letter them Z, Y, X, and W. Then reduce to 1 and the others would already be configured when I want to add them again. 20 seconds total.
With the new method I now add one, wait, set it, add one, wait, set it, add one, wait, set it, remove one, wait, remove one, wait, remove one, wait. Maybe 4 minutes.
Is there some obvious feature I'm overlooking to make this simpler?