Tweet
Operating System: Windows Server 2003
Burning Software: N/A
Anti-virus Software: None
DAEMON Tools Version: 3.41
Hey hey!
I just recently switched over from XP to Server 2k3, and I've been trying to get Daemon Tools to work on this sucker
. The most recent 3.44 release wouldn't install due to "invalid installer instructions", so I went back to the MSI installer for 3.41 and it installed properly... but the virtual SCSI driver simply refuses to load. The driver "installs" properly, as in it finds the driver, but then it gives a code 10 (device cannot start) and the ST3SHARK SCSI Controller just sits there with its bright yellow exlamation mark icon beside it...
Anyhow, from everything I've read, 2003 isn't "officially" supported, but I'm hoping that someone can lend some suggestions on how I can get the SCSI driver to load up... *crosses fingers*
Burning Software: N/A
Anti-virus Software: None
DAEMON Tools Version: 3.41
Hey hey!
I just recently switched over from XP to Server 2k3, and I've been trying to get Daemon Tools to work on this sucker
. The most recent 3.44 release wouldn't install due to "invalid installer instructions", so I went back to the MSI installer for 3.41 and it installed properly... but the virtual SCSI driver simply refuses to load. The driver "installs" properly, as in it finds the driver, but then it gives a code 10 (device cannot start) and the ST3SHARK SCSI Controller just sits there with its bright yellow exlamation mark icon beside it...Anyhow, from everything I've read, 2003 isn't "officially" supported, but I'm hoping that someone can lend some suggestions on how I can get the SCSI driver to load up... *crosses fingers*