standby problem with 3.44

[novrain]

Operating System: Windows XP SP1
Burning Software: None
Anti-virus Software: Symentac AntiVirus CE 8.1
DAEMON Tools Version: 3.44

Hi, I am using D-tools 3.44 on a laptop (windows xp sp1). I usually set the number of drives to 0 (disabled) then exit the D-tools whenever I don't need the virtual drive. After installing 3.44 I found that, after each standby, if I enable the virtual drive again (set the number to 1);
it asks me to reboot to take effect. It seems that the device driver doesn't wake up after standby. 3.41 doesn't not have this problem though.

[Development]

You get reboot prompt immediately or after big delay?

[novrain]

After I set the drive number to 1, there's a delay of several seconds saying "please wait...". Then it prompts for a reboot.

[Development]

This will be fixed in next version - thanks for report.