Tweet
I have noticed that setting my NIC connect speed down to 10mbps can solve certain Install errors once your bin/cue image is mounted...
Also, I have a 3com 3C905B-TX 100/10 NIC. I have options under the cards properties called TX and Rx checksum offload which are enabled by default (well at least for me they were).
DISABLING both of these allowed me to connect once again at 100mbps and also not getting the install errors I *always* experienced..
Perhaps if your NIC has a similiar option you should also try doing the above steps.
Hope this helps
NetSicK
Also, I have a 3com 3C905B-TX 100/10 NIC. I have options under the cards properties called TX and Rx checksum offload which are enabled by default (well at least for me they were).
DISABLING both of these allowed me to connect once again at 100mbps and also not getting the install errors I *always* experienced..
Perhaps if your NIC has a similiar option you should also try doing the above steps.
Hope this helps
NetSicK